Configuring VM Management Estimated Reading Time: 2 Minutes The VM Management service module changes the status of the virtual machines (VMs) of a service when the status of the service changes. For example, when you suspend a service, Ubersmith disables its VMs. When you unsuspend the service, Ubersmith enables and starts the VMs again. The module works with VMs on Virtuozzo and SolusVM hosts. It does not bill for the VMs. Before you start Set up your virtual machines in Ubersmith: Add a device for your VM host, with the VM Host device module. For more information, refer to the article "Configuring Virtual Machine Host Devices". Add the Virtual Machine device module to the device type of your VMs. For more information, refer to the article "Configuring Virtual Machine Modules". Add a device for each VM. For more information, refer to the article "Creating Virtuozzo VMs and Devices". Add the VM Management module to a service plan Open the service plan. For more information, refer to the article "Adding Service Plans". In the Service Modules box, click add module. The Add Service Module window opens. On the Details tab, in Module, select VM Management. Make sure that Enabled is YES. On the Config tab, select the action for each change of the service status. See the table below. Click Save. Field When the service⦠Actions Default On Service Suspension is suspended Disable VM or Do Nothing Disable VM On Service Unsuspension is unsuspended Enable VM or Do Nothing Enable VM On Service Cancellation is canceled Disable VM, Destroy VM, or Do Nothing Disable VM On Service Reactivation is reactivated after a cancellation Enable VM or Do Nothing Enable VM On Service End is canceled because its end date has passed Disable VM, Destroy VM, or Do Nothing Disable VM On Service Deactivation is deactivated Disable VM, Destroy VM, or Do Nothing Disable VM The actions do this: Disable VM: Ubersmith disables the VM on the VM host. Enable VM: Ubersmith enables the VM and starts it. Destroy VM: Ubersmith destroys the VM on the VM host and deletes the VM device from Ubersmith. Do Nothing: Ubersmith does not change the VM. Destroy VM permanently destroys the VM and its data. You cannot undo it. If you are not sure, select Disable VM. If a VM is destroyed, On Service Reactivation cannot enable it again. Associate the VMs with the service The module acts on the VM devices that are assigned to the service. Assign each VM device to the service of the client. For more information, refer to the article "Associating Devices with Clients and Services". On the service, the VM Management box lists the VMs of the service, with the status of each VM. If no VM is assigned, the box shows "No associated VMs found."