Configuring Power Management

Power Management

The Power Management service module controls power ports for any associated devices. When a service is suspended or canceled, the power port is turned off. When a service is reactivated, the power ports is turned back on.

In order to begin billing for this service, you need to configure Ubersmith. Once all the necessary pieces have been configured, any current or new service based on the service plan will be ready. The configuration steps are as follows:

1. Create a generic power management service plan 
2. Configure the Power Panel device module 
3. Configure your power device.
4. Add the Power Management service module to your service plan.
5. Create a power management billing service 
6. Configure the service plan with the service module fields.
7. Associate your device to your service